Correct Way To Start Tongue And Groove Siding

If the siding is up to 6 inches wide it can be nailed with one siding nail per bearing but siding any wider should use two nails per bearing.
Correct way to start tongue and groove siding. Start by taking a sharp eye to the entirety of your home s perimeter looking. Nail up the first panel at a corner of the room with the tongue side facing out. The nail can be started with a normal carpenter s hammer and then made flush with the surface of the groove by means of a nail set. Use the framing gun to add a nail to the tongue of the plank and secure in place.
The next grooved edge will hide the nail holes. To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall. The paneling will be nailed directly to these furring strips. For the best look alternate your seams moving from left to right and then right to left can help with this.
Both types of paneling come in a variety of. How to replace tongue and groove siding 1. Once you start to get into the rhythm of installing your tongue and groove walls you ll find that the process is extremely quick even for relatively large rooms. On the side of the building the roof angle was three pitch so we knew we had to cut our tongue and groove cedar boards at a 15 degree angle.
This is part 1 of a 3 part series. Nails should penetrate 1 1 4 inch into solid wood behind the siding. Start with your first piece. For the next piece you will connect the groove of the new piece into the tongue of the first piece.
Installing tongue and groove requires more precise nailing as you ll need to hammer the nail right through the planks tongues for secure results. Install planks with the tongue up. In horizontal application start at the bottom and work up with the groove edges facing downwards. Groove facing the wall tongue facing out.
Figure out how much lumber you need. Tongue groove installation tongue and groove siding can be installed horizontally or vertically. Pry out the old. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue.
Nail at an angle directly through the tongue and into your studs. Finding your replacement boards can be tricky especially with an older house with siding. You don t need to nail through the face of the planks anywhere but on the bottom row and near the ceiling. Drive the nails through the shoulder of the tongues into the framing at about a 45 degree angle.
The tongue section of the board should be at the top with the groove section at the bottom.